Description
Dynojet Power vision 3 device custom tune package. This kit is designed to accommodate guys that have a custom-built engine that requires a custom developed tune. This tuner kit allows you to data log all needed parameters in order to develop a custom tune.
This kit includes:
Dynojet PV3 tuner device
Dynojet PV3 wideband o2 sensor kit
Dynojet tune license
Custom Gilomen Innovations Custom Tune
TUNING AND DATA LOG INSTRUCTIONS:
- Install the dynojet tuner and wideband o2 sensor kit
- Turn the ignition key on so it powers up the dynojet device, which allows it to automatically create a PV-INFO file.
- Disconnect the dynojet PV3 device and connect it to your PC or Laptop and email the PV-INFO file to terry@gilomeninnovations.com
- Standby until the new base tune is created and emailed to you
- Install the new base performance tune
- After you install the kit, you will need to send several data log files to terry@gilomeninnovations.com
- Cruise around for about 15-20 minutes to get the engine fully warmed up
- Then create 3 data log files.
#1 log file should be of the engine idling for about 3 minutes.
#2 log file from idle slowly roll into the throttle until you reach full throttle then let off.
#3 log file would be a three-second full throttle acceleration pull from a rolling start. - Email the log files to terry@gilomeninnovations
- Standby for the new tune file to be emailed to you. It usually takes about 3-4 times of doing this process in order to get the tune fully dialed in.
- Then create 3 data log files again.
#1 log file should be of the engine idling for about 3 minutes.
#2 log file from idle slowly roll into the throttle until you reach full throttle then let off.
#3 log file would be a three-second full throttle acceleration pull from a rolling start. - Email the log files to terry@gilomeninnovations